AEG has gone limp

[Raptor]

Hello, I have G&G AEG and mid battle it went limp...the BB would just pop out the end....I had someone look at it (he had no clue Abt airsoft guns) he broke a pin on the motor...shld I buy a new motor or is the not the problem (the limp bit not the broken pin)

 

[Cr0-Magnon]

a possible culprit and easiest check would be the hop rubber and nub - ie make sure they're intact and fitted correctly.

 

[RostokMcSpoons]

I had someone look at it (he had no clue Abt airsoft guns) he broke a pin on the motor

Click to shrink...

Blimey, it's bad enough when the person does know about airsoft guns...  you must be one of them high-flying risk-taking go-getter types to let a noob loose on the complicated internals of your gat!

 

[Speedbird_666]

Fiver says it's a stripped piston.

 

[Shamal]

Yep as @Speedbird_666says probably a stripped piston.

Sounds like you need a new motor as well. When you say pin do you mean the terminal where the red or black wire connects?

If you are handy with a soldering iron you can maybe get over that problem.

Lesson learnt though?

Good luck?

 

[Pseudotectonic]

Fire upside down and without mags, just drop a BB into the feeding hole, does it fire normally?

 

[#blackadder]

Tappet plate spring