Torch pressure switch mounting

[E21A]

I’ve bought myself a rail mounted torch with pressure switch for an upcoming visit to the mall. Question is where do I mount the switch? 

Any suggestions appreciated. I’m currently thinking on the foregrip but I’m all ears 

 

[P13]

Do you use a handgrip? Could mount to this or on handguard rails. 

 

[L3wisD]

Mine is wiggled through the keymod handguard and held onto my vertical grip with self-amalgamating tape.

Does the job very well 

 

[E21A]

Mine is wiggled through the keymod handguard and held onto my vertical grip with self-amalgamating tape.

Does the job very well 

Click to shrink...

This is exactly what I’m thinking of doing. Good to know it works well. 

 

[Shaun Haynes]

Cable tied mine on the rails 

 

[MisterG]

I stick mine to the foregrip with sticky back velcro.

 

[Prisce]

Mine is electrical taped to the magwell.

 

[Duff]

Threaded through the rail and grip and held in place with tape of some kind.

 

[M_P]

I prefer mine on the side of the fore-end above a vertical grip but everyone's different. Get something non-permanent like cable ties and try it in a number of places and see where you like it best

 

[jcheeseright]

When I used one I preferred the switch on a vertical grip, though that’s only because I put the switch for my PEQ on the 11 o clock position on the rail.  If you’re not using a laser then that’s where I would go,  sits perfectly for your thumb