TM G36C Stock Removal - M4 Adaptor

[dangermouse425]

Hi all,

Does anyone have a guide on how to remove the G36 folding stock backplate to replace it with an M4 stock adaptor?

It's one of these: http://www.ebay.co.uk/itm/320938094799?ssP...984.m1439.l2649

 

[dazzer306]

Don't about TM G36 but on SRC one if you open up stock there should be be a small grub/retaining screw on the bottom of the hinge unscrew and then tap out pin hope this helps

 

[rschris]

Like this?

Basically you have to collapse the stock. there is one retaining bolt that is on the back of the gun.

then drop the bolt out the swivel

M4 adaptor then needs to be put on using the same screws

let me know if you need help

 

[dangermouse425]

Don't about TM G36 but on SRC one if you open up stock there should be be a small grub/retaining screw on the bottom of the hinge unscrew and then tap out pin hope this helps

Basically you have to collapse the stock. there is one retaining bolt that is on the back of the gun.
then drop the bolt out the swivel

M4 adaptor then needs to be put on using the same screws

let me know if you need help

Cheers, guys, it was the tiny grub screw I had missed! I don't have an allen-key that small! Will need to buy one from somewhere before I get started on my G36 conversion!

 

[rschris]

Another bit of advice before you do it all up and realise it has movement. Stick something underneath that is about 5mm thick....I used a bit of old knee pad cut to the right size which stops movement in the stock once all done up.

You also need to get a longer stock screw than normal. Got mine from homebase.