Strippling a Hi Capa Grip

[emilianoksa]

If I wanted to stipple my TM hi capa grip would I have to use a dremel to remove the not very good stippling pattern already on it from the factory, or could I just go over it.

I am not thinking of fancy geometrical designs - just a simple small dot stipple.

I imagine I would have to remove the pattern on the front of the grip, but what about the sides?

 

[MiK]

Most videos show the full dremelling of the whole grip then they get to work with a soldering iron with various tips.

I think if the current texture is there it will give a “meh” result on the new stipple.

 

[Steveocee]

@emilianoksa You can go straight over the stock stuff. (Video wasn't taken for purpose of showing grip but you get the idea).

View attachment 68013

 

[emilianoksa]

Thanks for the replies.

What about custom grip tape cut out for the hi capa? Can it just go over the factory TM grip finish, or does the grip need to be sanded first?

 

[Steveocee]

You'd probably need to sand that as the tape wouldn't adhere very well to a stippled surface.

 

[concretesnail]

Having done it both ways it depends on the pattern you want to end up with and what tips you have available for your use.

I'd suggest a larger flat tip for a base pattern/texture then a smaller tip to refine then pattern. The larger tip can be used to create a base shape without mass removal of material giving you more meat to work with, and if it all goes wrong that margin can be dremeled off and you can have another crack at it.

 

[emilianoksa]

Thanks