SRC SR1911

[Wohmsc]

Hey everyone, I need some advanced tech help with a brand new SRC SR1911 (Green Gas). It completely refuses to fire or release any gas when fully assembled. I have systematically gone through the standard troubleshooting steps with a helper, and we have definitively debunked all the usual culprits.
Here is the exact state of the gun and everything we have proven so far:

1. The Lower Frame is 100% Functional

• The Test: With the slide completely off the gun, inserting a gassed magazine and tripping the sear works flawlessly.
• The Result: The valve knocker cleanly snaps forward, locks forward via the valve lock pin, and dumps gas perfectly 100% of the time. The grip safety and thumb safety operate exactly as intended. Pushing the disconnector disables the hammer drop properly.

2. No Magazine Alignment or Gas Lock Issues

• Mag Height/Position: Shifting, pushing up, or physically pulling down on the magazine with the slide off makes no difference—the valve knocker has plenty of reach and activates the valve regardless of position.
• Gas Pressure: It is not an over-pressure / light-strike issue; the hammer spring has plenty of force to crack the valve under normal pressure.

3. The Isolated Variable: The Hop-Up Unit

• The Big Breakthrough: If I strip the slide completely (removing the outer barrel, inner barrel, and hop-up assembly) and put the empty slide shell + Blowback Unit (BBU) back on the frame, the gun fires and vents gas perfectly.
• The Conclusion: The failure to fire only triggers when the hop-up unit/barrel assembly is installed in the slide and pinned to the frame via the slide stop.

We are at a complete loss of ideas for what is causing the issue, so any help will be greatly appreciated.

 

[mec]

If its brand new, take it back to the shop?

 

[Cannonfodder]

As above. If it's new and under warranty then the shop have an obligation to give you replacement or refund. Fixing it yourself will only invalidate said warranty, probably cost you more and leave you with a very expensive paper weight if your fix doesn't work.

I never understand why so many airsofters are happy to accept broken or sub standard parts when they don't need to

 

[Punisher3990]

Not just that if you tinker around with it and replace parts etc, you will likely void any chance of a return. I'd just return it and get a replacement if possible could be a QC issue, or it was a "returned new" (we all know a certain shop that I will not name P****L B**E that likes to send out used items as new ones so i guess other do too)