RIS Riser help

[Albiscuit]

I have a magnifier and eotech but they do not line up properly. The magnifier has built in adjustment but only to make it taller and it currently sits about 5 - 10mm too high to line up properly with the sight.

Struggling to find and doubt I will a RIS Riser with such a small increase. Most seem 25mm, while this may work if I then adjust the magnifier upwards I would rather find the lowest profile one possible.

Any ideas on options or other tricks I could use, or should I just reorder a new magnifier?

 

[Hangtight]

https://www.amazon.com/UTG-Low-Profile-Compact-Riser-Mount/dp/B003TWZFOC

 

[Ninjacabbage]

http://www.ebay.co.uk/itm/Low-Profile-20mm-Weaver-Picatinny-Scope-Riser-Rail-Mount-8-Slot-Quick-Release/222517202372?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

 

[Hangtight]

Ah, someone else who Googled 'low profile RIS riser'...

 

[Albiscuit]

spent ages looking around, but only looked for RIS Riser 

didnt think the obvious