My hopes are up again!

It looks promising. If it were GBBR and MWS compatible, I'd tell them to just shut up and take my money.

 
I think it's based on a existing foam dart molding. It's not going to be good. there is no room for one of the existing versions of airsoft gearbox so it's going to be proprietary. I still don't care I'll buy one and carry on with my 3d printed GBB project. I have several real steal parts, folding stock, trigger guard, heat shield, mags and old maruzen springer gas block, a file for the receiver and learning fusion 360 to design bolt and hop unit mount (think of using a VFC AR hop).

 
I wonder why they modelled it on one with a barrel strut? Maybe they know it'll be shit out of the box!

 
There is an airsoft 22 version so it shouldn't take much to change the mag well to take 5.56 sized mags.

 
I like it, but I'd be doing something about that barrel/front sight, too long, too skinny.

 
I  hopefully will be getting the 1st release shortly. fingers crossed. I may buy a stainless one later then get another two black ones get a couple Muzzelite MZ14 Bullpup kits make a Moritia as well as a Human Resistant fighter. 

 
That looks very interesting and very fragile.

 
Last edited by a moderator:
Oh, Mama...

Thanks for the link, I've added one to my basket but will hold off until there's more info, I'm only concerned about the picatinny version v the one with iron sights.

 
You must log in or register to reply here.
Back
Top