NiallAckroyd
Members
- May 10, 2014
- 25
- 5
So, I just got a gas blowback glock 17, and I'm a little confused on how I lubricate it. Can anyone help?
-
Hi Guest. Welcome to the new forums. All of your posts and personal messages have been migrated. Attachments (i.e. images) and The (Old) Classifieds have been wiped.
The old forums will be available for a couple of weeks should you wish to grab old images or classifieds listings content. Go Here
If you have any issues please post about them in the Forum Feedback thread: Go Here
Just Got A Glock and I'm a touch confused.
- Thread starter NiallAckroyd
- Start date
Airsoft_Mr B
Members
- Jul 14, 2013
- 1,794
- 612
I can help a bit, went Patrol Base about an hour ago and they showed us.
You'll want a bottle of silicone oil like this: http://www.patrolbase.co.uk/gas-and-lubrication/abbey-silicone-gun-oil-35.htm#.VEAQmvldXWg
Also bought some of this, use after the skirmish day but it says on the website after every ten magazines: http://www.patrolbase.co.uk/gas-and-lubrication/abbey-predator-maintenance-gas-144a-20ml.htm#.VEAQ2_ldXWg
Couple drops on the gas router and valve of the mag before shooting.
Also some oil on the slide and firing mechanism.
Finally, always leave a bit of gas inside, otherwise the seals will dry out.
You'll want a bottle of silicone oil like this: http://www.patrolbase.co.uk/gas-and-lubrication/abbey-silicone-gun-oil-35.htm#.VEAQmvldXWg
Also bought some of this, use after the skirmish day but it says on the website after every ten magazines: http://www.patrolbase.co.uk/gas-and-lubrication/abbey-predator-maintenance-gas-144a-20ml.htm#.VEAQ2_ldXWg
Couple drops on the gas router and valve of the mag before shooting.
Also some oil on the slide and firing mechanism.
Finally, always leave a bit of gas inside, otherwise the seals will dry out.
NiallAckroyd
Members
- May 10, 2014
- 25
- 5
- Thread starter
- #3
Thanks for the help, i got them exact products from patrol base too. So its just a couple of drops of the silicone oil in the small rectangle shape in the slide and the same thing on the top of the mag? He showed be too, but to be honest, I cant really remember.
Last edited by a moderator:
Airsoft_Mr B
Members
- Jul 14, 2013
- 1,794
- 612
Yeah I think so, that sounds right. I've put two drops in the rectangle thing on my mag and one on the valve at the back of the mag. I think I remember he pulled back the rectangle gas router thingy (the one in the slide) and then put a drop sort of behind it (towards the back of the gun) not sure if this was right though. In the manual for the P226 it shows putting one in the gas router on the mag.
straffham
Members
- Feb 1, 2014
- 714
- 272
The important thing is not to flood any part in silicon oil, in particular try and avoid getting any in the hop rubber as it will affect the hop effect and thus range (although a little will inevitably get sprayed through the whole gun during the firing cycle which can't really be avoided). Literally a drop in the gas inlet and outlet valves after use is usually sufficient. A very small amount of silicon grease smeared on with a finger works better than oil on the rubber gas router, as the oil will get blown out more quickly.
Similar threads
