Chev Chelios
AF-UK patch owner
- Dec 24, 2017
- 344
- 322
Do a lot of lurking so felt I should contribute something, even its just this pish.
Glock triggers are wank, soft and mushy as my little man after 10 pints! Just did this to a mates so thought I would stick up a pic. 2.5mm hole, 3mm grub screw (6mm long in this case) and tap. By adding the grub screw you are preloading the trigger using the trigger bar. Spend the money you save on an adjustable trigger and get some stronger trigger springs for a better than the real one, pull and reset https://www.rainbow8.com/collections/glock-series/products/customized-production-steel-trigger-level-spring-150-for-marui-g-series
The hop up and thus barrel sit very loose on the frame, by adding some shimming (in this case self sticking steel shim tape) to the frame where the hop unit locks in to you can remove 99% of the play thus leading to be much more accurate. Go slow, fit the hop and barrel to the frame without the slide and outer barrel and leave it loose enough so you can still disassemble. For shimming you can use just about anything paper/card with glue even fuzzy side Velcro.
Will post up the barrel drop mod next time i do it if anyone cares.
Any mods you could share and add some value to this post?
Cheers big ears.
View attachment 77061
View attachment 77062
Glock triggers are wank, soft and mushy as my little man after 10 pints! Just did this to a mates so thought I would stick up a pic. 2.5mm hole, 3mm grub screw (6mm long in this case) and tap. By adding the grub screw you are preloading the trigger using the trigger bar. Spend the money you save on an adjustable trigger and get some stronger trigger springs for a better than the real one, pull and reset https://www.rainbow8.com/collections/glock-series/products/customized-production-steel-trigger-level-spring-150-for-marui-g-series
The hop up and thus barrel sit very loose on the frame, by adding some shimming (in this case self sticking steel shim tape) to the frame where the hop unit locks in to you can remove 99% of the play thus leading to be much more accurate. Go slow, fit the hop and barrel to the frame without the slide and outer barrel and leave it loose enough so you can still disassemble. For shimming you can use just about anything paper/card with glue even fuzzy side Velcro.
Will post up the barrel drop mod next time i do it if anyone cares.
Any mods you could share and add some value to this post?
Cheers big ears.
View attachment 77061
View attachment 77062
Last edited by a moderator:
