Request for Photos of P90 Trigger Parts

[Nogl]

Hi,

Bit of a funny one this,  but is anyone able and willing to take some detailed photos/measurements of the trigger bar from a tm compatible p90?

I've been repairing a heavily damaged p90 and need a new trigger bar but they're pretty unavailable. With enough photos and some rough measurements I could probably design a 3d printable one that would also benefit someone else eventually. 

 

[Rogerborg]

I've been repairing a heavily damaged p90

Have you considered that perhaps God wants it to die?

 

[Nogl]

It's an angry rectangle! What's not to like?

I was a huge Stargate fan and always wanted one, it's a close as I'm going to get without dismembering a ruger 10/22

 

[Shamal]

It's an angry rectangle! What's not to like?

I was a huge Stargate fan and always wanted one, it's a close as I'm going to get without dismembering a ruger 10/22

It reminds me of a giant gas lighter.

?

Regards 

 

[Nogl]

Haha The ps90 is definitely for lighting ovens.

I'll probably end up bending something from wire or cutting it from an alu sheet and fitting by trial and error. 

 

[Shamal]

Haha The ps90 is definitely for lighting ovens.

I'll probably end up bending something from wire or cutting it from an alu sheet and fitting by trial and error. 

I had trouble getting a stupid spring for my we smg mp7 gbb.being the tight arse that I am and not wanting to pay $20 to get it shipped from Hong Kong I made my own. After few attempts! Lol

Works fine.

Good luck with yours.?

Regards 

 

[Nogl]

I'd rather spend 40 on a tool to make the part than 20 on the part (and then not make the part)

I spent around 4 months getting CAD training at my local collage to a supplement a 3d modelling degree and I still haven't actually put any of my own parts on shapeways

Update: Waiting for parts, project not dead