SAR-21 custom

[ryanlim2000]

Hey, 

Not sure where this goes, but I'm planning to get an ICS L85 or a spring L85 to tear it apart and put a 3D printed SAR-21 exterior on it. I've been advised previously to get an AUG, but due to the cost of AUGs against the L85, I'll probably go with it. 

Been looking at 3D printing for the parts and its come up to around USD70-100 for them to design out the parts as per military specifications, but I've not checked for the cost of 3D printing yet. The 3D printing person was going to do it with all the rifle parts as well, but I'm not sure if thats a good idea, or how much of the rifle parts to keep. The main issue I'm facing is that the firing chamber is part of the system that holds the rifle in place and how would I fit an AEG or spring rifle's parts inside this "shell"

Cheers

View attachment 36334

View attachment 36333

View attachment 36335

View attachment 36336

View attachment 36337

View attachment 36338

View attachment 36339

View attachment 36340

View attachment 36341

View attachment 36342

View attachment 36343

View attachment 36344

View attachment 36345

View attachment 36346

View attachment 36347

View attachment 36348

View attachment 36349

View attachment 36350

View attachment 36351

View attachment 36352

View attachment 36353

View attachment 36354

View attachment 36355

View attachment 36356

View attachment 36357

View attachment 36358

View attachment 36359

View attachment 36360

View attachment 36361

 

[Duff]

Damn. Those photos are clean.