Problem....

[JerseyRider]

Hi guys,

I have came to the point where i need to route the wires into the handgaurd... but i carnt see how to do it!?

Any help?

Thanks guys again

Jack

 

[Deva]

Well where exactly are you stuck?

 

[JerseyRider]

Feeding the wires though into the delta ring and out into the hand gaurd.... i carnt see like a hole or anything :S

 

[Rock-climby-Dave]

should be a small opening just above where the hop up would be if the gun is turned the 'right way up'

push the wires through that and they then pull down (same again, with the gun 'right way up')

there is no clear line straight through, it is an L shaped hole, but should be there on most M4's

 

[Matt!]

as above if you remove the Hop and inner barrel its 10X easier.

May have to remove the outer barrel if your seriously struggling.

 

[JerseyRider]

I have found that whole but it looks blocked to me :S as i carnt see a hole on the opposite side??

 

[Rock-climby-Dave]

the hole is there, but like I say, it's an L shape, so viewing the hole all the way can be tough, just stick a small piece of wire into the hole you can see, then look at the other end of where the hole should be and it should be visible.

 

[JerseyRider]

Looking at Matts Pic... mine is differnt you can see in that pic that the flat bit of the out barrel is faceing up so there is space for the hole..

On mine the flat bit is faceing side to side therefore blocking the hole??

You can kinda see it on this pic if you zoom right in (Hold CTRL and scroll at the same time)

The only way i can see to do it is drill a small hole thorugh the Upper Reciver and feed it past the outside of the D ring and into the handgaurd that way??

Yer it wont look as good but as long as it works?

 

[Matt!]

take the outer barrel off should make view of the hole easier

 

[JerseyRider]

How do you do that? lol