Optic/riser issue

[Hamster82]

Hi all, yet another cry for help! ?

I’ve just got an holo/magnifier set up and they don’t quite line up.

View attachment 87253

I can still get a sight picture but the reticule is very low, playing about I need to raise the holo about 5-6mm and am struggling to find a way.

I’ve seen these which would be great if they weren’t reducers and were 20mm both sides.

View attachment 87254

I’ve searched pretty much the whole t’interweb and can’t find anything less than 10mm and hoping someone here might know what I need to get just that little bit of extra height.

cheers, Col

 

[concretesnail]

I haven't seen any riser that are 5mm lift but I have found risers with a difference of 5mm ish. It my be cas eof lifting then both to greater or lesser degree.

Ant suppliees was where I saw the riser and utg do a range too, some very minimalist riser sections.

 

[Guest]

I’ve not used a 5mm riser myself, but this looks like it will work

https://www.shapeways.com/product/QQCBYM62Q/1-4-quot-high-7-slots-hybrid-picatinny-weaver-riser

 

[Lozart]

Hi all, yet another cry for help! ?

I’ve just got an holo/magnifier set up and they don’t quite line up.

View attachment 87253

I can still get a sight picture but the reticule is very low, playing about I need to raise the holo about 5-6mm and am struggling to find a way.

I’ve seen these which would be great if they weren’t reducers and were 20mm both sides.

View attachment 87254

I’ve searched pretty much the whole t’interweb and can’t find anything less than 10mm and hoping someone here might know what I need to get just that little bit of extra height.

cheers, Col

Not sure if it's a trick of the lens but it doesn't look like the magnifier is parallel with the rail - the front looks higher than the back. Which to be fair is pretty typical of that kind of mount.

 

[Hamster82]

I’ve not used a 5mm riser myself, but this looks like it will work

https://www.shapeways.com/product/QQCBYM62Q/1-4-quot-high-7-slots-hybrid-picatinny-weaver-riser

I saw this but £22 for a plastic riser with no real detail on how it fits/is secured kind of put me off

Not sure if it's a trick of the lens but it doesn't look like the magnifier is parallel with the rail - the front looks higher than the back. Which to be fair is pretty typical of that kind of mount.

Your not wrong, there’s a fair bit of movement in the mount as it’s a cheapy clone and depends on how I’m holding it or if it’s resting on something like the rif bag in the photo.

it’s not actually a bad magnifier despite that and I reckon if I could raise the holo even a few mm it would make a difference, just struggling to find a way.