6.05mm Barrel upgrade

[Hegs44]

So after much time at work trying to source a 6.05mm bore aeg barrel I've found just about every tight bore barrel in existence.

I'm looking to get R-Hop done and want to upgrade barrel at the same time.

6.03 there are loads of. I understand from much reading this is at the edge of R-Hop effectiveness.

Over to the forum for opinions and thoughts.

I'm upgrading a G&G CM16 SR FOR accuracy purposes, 260mm inner barrel.

Ta

 

[PT247]

Did the barrel I gave you not work out? With your CM I'd be more inclined to try a better bucking/nub combo before going the R-hop route but whatever you decide you def need to increase the fps, an upgraded bucking may help with that and a tighter bore barrel would also up the fps

 

[Hudson]

PDI 6.05 from x-fire, if you don't mind ordering from abroad.

 

[cyrexx]

What Hudson said, X-fire are PDI's shop.

If your going to R-Hop your first barrel expect it to be naff, I've never seen anyone fit an R-Hop perfectly on thier first attempt. It's usually why people say R-Hops are not that good, as they've tried fitting one them selfs and done a poor job.

 

[Hegs44]

PT247, yeah all good with that barrel (TY) and got new bucking, Hop Up and 2.03 TBB on order to try/test all combinations to my liking ;-)

 

[proffrink]

2.03? That's a VTBB.

 

[PT247]

finding the combination that works best for you and your gun is always a bit of an experiment. As said the PDI barrels are the best out there but also not cheap, I like Prometheus barrels too.