Search results for query: *

I know for certain they make reversed polarity motors for SVD users, I guess if one asks nicely they can make whatever the V1 uses, of course it won't be cheap but worth asking nonetheless

1000iq play: get a solink advanced motor with uni bearing and tell the arl to fuck off :)

You shouldn't use ptfe tape to seal parts, usually a decent amount of lube (grease, oil, your call) does the trick.. if it's still leaking then replace the o-ring or get a slightly fatter one. Check all the seals again, also check if the nozzle is making good contact (and seal) with the hop...

italian forum is dead and it was never a good source of information anyway, I realized that if I wanted information and knowledge I would need to look elsewhere :) I've been plaguing this place since 2017 :P

Not quite. When the piston is released the tappet plate is already forward, pushing the nozzle into the hop rubber thus creating air seal. If you pay attention to the placement of the sector gear cam in relationship to the tappet plate's pick up point you will notice that there isn't a whole lot...

Then wtf are we both doing here?:unsure::ROFLMAO::ROFLMAO:

But mind you, I'm in Italy :P Although I'm pretty sure they will post to the uk

Plenty of times :P They have an okay selection of niche parts and somewhat more reasonable prices than other SM stores

Tappet timing is off and brushless motors are VERY good at exposing it :ROFLMAO: What happens is that the tappet plate gets picked up before the piston ends its travel against the cylinder head. Have a look at how piston, sector gear, delayer and tappet plate work with each other and you'll...

So delusional..

Is the switch between modes light and crisp?

Without changing a few parts there is only so much you can do. Surely a complete gearbox cleanup, (proper) reshim and relube will help with sound, rate of fire and general consistency but it's marginal. A better hop rubber will allow you to use heavier BBs like 0.28s and experience a...

nooooooo all my senseless ramblings!!

Well it's up to the server owner/mod, there are ways to make locked threads with guides and stuff like this, have threads dedicated to pictures/videos and anything in between. I'd stay away from huge servers like Airsoft International, that place is an absolute shithole and everyone there is...

Kit for last weekend's National Finals (more, probably, on the horror story thread). SOD Gear combat shirt in A-Tacs iX; ClawGear Operator Pants in RG; LaSportiva Ultra Raptor II Leather-GTX; Mayflower UV Gen IV rig in RG; FRV Tailoring belt; Source Commander pack in Multicam. Gun is my...

Good times, when trees spoke Vietnamese 

A bit late to the pary, but Lonex flash mags are your best bet. I recently replaced the ones i bought in 2016, they're still working after almost 10 years of absolute neglect (leaving them with springs compressed for weeks, they're rusty to all fuck) but never skipped a beat. 360 round...

Yes, as long as it isn't some stupid "high speed" motor. By high speed I mean those 40k+ neodymium motors, they're overly expensive for what they are and very limiting in upgrade routes. Usually it's the opposite, especially when a weak motor is trying to pull a somewhat stiff spring. Care to...

Same, I still have it (old version, silver with red wheel) and it wouldn't fit any of the AEGs I had at the time... Be careful when picking hop units, due to tolerances and shit you may need a different nozzle or to make a few spacers.