Recent content by JVacation

To be honest contact lenses are the best way to go. They are a pain when you first get into them but after a month or so they're easy to get in and out.  The run a pair of herosharks and you'll forget fogging exists

The quietest aeg that you can make is most likely something like an Aug or previously mentioned an F2000. The gearbox is very enclosed and the areas around it can be padded out with foam and etc for further sound proofing.  Although that's only if all variables between all the different aegs...

When I wrote this post a couple days back I did not expect it to cause so much traction! 

I still think the best and easiest way to do it is: 1) Player goes to chrono and says what weight they are using 2) Marshall chooses a random amount of shots through the chrono  3) if all readings are in the limit; remove the mag and take a sample of bbs.  4) Weigh the bb on some micro...

That's not true. If you turn up to the chrono and say you are using a 0.2g; the fps limit will the be 350 with joules at 1.13j and that's what the person doing the chrono will be checking.  If you have a mag of 0.32g instead which is firing at 350 fps the joules is at 1.82j   Unfortunately...

In reality it is quite easy to cheat the chrono by just saying you are using a different bb weight than you are actually using. Some sites make you chrono and then take a single bb from the mag you used and weigh it. I understand it would take longer but it is something that would be good to...

You can try leaving it pre-cocked, just be careful with it and don't leave it too long. The main thing to remember is that chronos read differently between each other. Even the same brand and model can read differently. I know that my chrono reads about 10 fps higher than the one at my normal...

Do you know which mosfet is in it? Some have cyma oem ones and some have eshooter in it. 

If I remember correctly they had a bit of a falling out with Warhead in general. I think it was due to the people at Warhead UK thinking that the support from Warhead global was inadequate and then warhead global tried cutting them off. Luke was posting stories on his Facebook saying that they...

I've had it work on Cyma triggers so would assume it would work on quite a few. You are right though mentioning the metal content.  AK triggers are in general a pain, The Perun Clicker does help a lot though if you are running a perun.  

A little trick with a V3 trigger and for other things. Use neodymium magnets to aid in holding the trigger in a little bit. Pop them on the opposite side of the case and most triggers will get held in by them. Also really handy for holding the anti reversal latch in. 

The annoying thing about LMGs in the UK is that the majority of sites do not have rules where they benefit over your typical assault rifle. I know Rift allow a little increase in joule limit and a longer full auto when mounted but it also introduces an engagement range. You also have to carry a...

I wonder if the Cyma platinum v3 has been fixed yet. The first batch the 1st tooth of the sector gear would clip the 2nd tooth on the piston slightly. In theory it should be fine but not the quality you would expect from their platinum series.

Yeah just hand tight until it stops twisting on.  Usually it will twist on easy at the start, then get a little harder stop until you are met with that "brick wall"